亚虎国际老虎机网站

OBD Codes
Your OBD-II Trouble Codes Repair Site

P2052 Reductant Injection Valve Circuit High Bank 2 Unit 1

OBD-II Trouble Code Technical Description

Article by
Stephen Darby
Stephen Darby
ASE Certified Technician

reductant injection valve circuit high bank 2 unit 1

What does that mean?

亚虎国际老虎机网站this diagnostic trouble code (dtc) is a generic powertrain code and applies to many obd-ii vehicles (1996-newer). that may include but is not limited to vehicles from ford, mercedes benz, sprinter, smart, ram, etc. although generic, the exact repair steps may vary depending on year, make, model and powertrain configuration.


 

亚虎国际老虎机网站a stored code p2052 means that the powertrain control module (pcm) has detected excess voltage in the control circuit for the reductant injection valve for engine bank two and selective catalyst reduction (scr) system one. bank 2 refers to the bank of the engine that does not contain the number one cylinder.

亚虎国际老虎机网站the catalyst system is responsible for reduction of (basically) all exhaust emissions although certain applications are also equipped with a nox trap.

亚虎国际老虎机网站exhaust gas recirculation (egr) systems go another step further in the reduction of nox. nevertheless, today’s larger and more powerful diesel engines cannot meet strict federal (u.s.) emission standards with the egr, diesel particulate filter/catalytic converter, and nox trap alone. it was for this reason that selective catalytic reduction (scr) systems were invented.

亚虎国际老虎机网站scr systems inject a reductant compound or a diesel exhaust fluid (def) into the exhaust in front of the diesel particulate filter, nox trap, and/or the catalytic converter via the reductant injection valve (solenoid). the precisely timed def injection elevates the temperature of the filtration element and allows it to perform more efficiently. it enhances filtration element longevity and allows fewer harmful exhaust emissions to be released into the atmosphere.

the entire scr system is monitored and controlled by either the pcm or a stand-alone controller (which interacts with the pcm). either way, the controller monitors the o2, nox, and exhaust temperature sensors (as well as other inputs) to determine the appropriate time for def (reductant) injection. precise def injection is necessary to maintain exhaust temperature within acceptable parameters and optimize pollutant filtration.

reductant heaters are used to prevent diesel exhaust fluid from freezing during extreme temperatures. these heaters are typically located in the def reservoir and/or the reductant injector supply hose/s.

if the pcm detects excess voltage on the control circuit for the reductant injection valve for engine bank two unit one, a code p2052 will be stored and a malfunction indicator lamp may be illuminated.


P2052

What is the severity of this DTC?

a stored code p2052 should be considered severe and addressed as quickly as possible. the scr system could be disabled because of it. catalyst damage could result if the conditions which contributed to the code being stored are not rectified in a timely manner.

What are some of the symptoms of the code?

symptoms of a p2052 trouble code may include:

What are some of the common causes of the code?

causes for this code may include:

What are some P2052 troubleshooting steps?

亚虎国际老虎机网站you will need access to a diagnostic scanner, a digital volt/ohmmeter (dvom), and a source of vehicle specific diagnostic information to diagnose a code p2052.

if you can find a technical service bulletin (tsb) that matches the vehicle year, make, and model; as well as the engine size, code/s stored, and symptoms exhibited, it could yield helpful diagnostic information.

亚虎国际老虎机网站you will want to begin your diagnosis with a visual inspection of the reductant heater system harnesses and connectors. burnt or damaged wiring and or connectors should be repaired or replaced before proceeding.

proceed by hooking the scanner to the vehicle diagnostic connector and retrieving all stored codes and pertinent freeze frame data. write this information down before clearing the codes and test driving the vehicle until the pcm either enters readiness mode or the code is reset.

亚虎国际老虎机网站the code is intermittent and may be much more difficult to diagnose (at this time), if the pcm enters readiness mode. if this is the case, the conditions which contributed to the code being stored may need to worsen before an accurate diagnosis can be made.

亚虎国际老虎机网站should the code be reset, search your source of vehicle information to obtain diagnostic flow charts, connector pin out charts, connector face views, as well as component testing procedures and specifications. this information will be required to complete the next step of your diagnosis.

use the dvom to test the power supply to the scr control system. test fuses with the circuit loaded to avoid misdiagnosis. if the appropriate power (battery voltage) and ground circuits are discovered, use the scanner to activate the reductant injector valve (solenoid) and test output control circuit voltage. if voltage is insufficient, suspect that the controller is bad or has experienced a programming error.

亚虎国际老虎机网站if the voltage output circuit is within parameters, use the dvom to test the reductant injection valve in question. if the valve fails to meet manufacturer’s specifications, suspect that it has failed.

Related DTC Discussions

Need more help with a P2052 code?

If you still need help regarding the P2052 trouble code, please post your question in our FREE car repair forums.

亚虎国际老虎机网站note: this information is presented for information purposes only. it is not intended as repair advice and we are not responsible for any actions you take on any vehicle. all information on this site is copyright protected.

乐优彩票天天红单下载 乐优彩票网址是多少 乐优彩票登入,备用,官方网址 乐优炫彩天天红单 乐优炫彩app下载 乐优炫彩app 乐博app下载是准的 乐优炫彩app天天红单 乐优炫彩官网 乐优炫彩彩票app下载